My cart:
0
Your cart is currently empty.
Creative Ceramics Moulds for Fusing, Slumping & Casting
This mould will create an ideal focal piece for a conference table, a large side board etc. To be a bit more creative you could create a perfect shield when you use the bottom of the glass a the focal side.
Recommended Firing Chart
Please Read: This firing recommendation has been calculated for use with Bullseye Glass of average viscosity with an even thickness of 4 - 6 mm. The chart shown below is also based on the assumption that you are using a top fired kiln, e.g. Paragon GL22, GL24, BVD Flat bed kilns etc. If you are using a side firing kiln you must allow more time in the first ramp.
958.355
9237 2.000000
Related Products (There are 16 other products in the same category)
