Candle Bridge - One - 14.2x16.5x3.9cm - Opening: 5.5x1cm - Fusing Mould

Candle Bridge - One - 14.2x16.5x3.9cm - Opening: 5.5x1cm - Fusing Mould

958.321

7562

CHF32.05
Tax included Shipping excluded

Creative Ceramics Moulds for Fusing, Slumping & Casting

This mould has been designed to create a Candle Bridge but this does not need to be its only use. It has an interesting topography which could lend itself as a template to create interesting pre-fabricated componants such as curved stringers etc.

All convex slumpings require careful positioning of the glass plus a good control of the slumping temperature, to stop the glass from ‘grabbing’ the mould.

Recommended Firing Chart

Please Read: This firing recommendation has been calculated for use with Bullseye Glass of average viscosity with an even thickness of 4 - 6 mm. The chart shown below is also based on the assumption that you are using a top fired kiln, e.g. Paragon GL22, GL24, BVD Flat bed kilns etc. If you are using a side firing kiln you must allow more time in the first ramp.
958.321

7562 0.550000

Related Products (There are 8 other products in the same category)

close Shopping Cart
close Shopping Cart