Drop Out Rectangular - 41.1x23.6x2.2cm - Opening: 28.5x10.5cm - Fusing Mould
958.323
7648
CHF71.99
Tax included
Shipping excluded
Creative Ceramics Moulds for Fusing, Slumping & Casting
Drop outs are a bit more tricky than other slumpings. Visual control during the process is necessary. The most even drop outs are achieved at low temperatures over a long time in a side fired kiln, e.g. Paragon Modell GL 24.
Recommended Firing Chart
Please Read: This firing recommendation has been calculated for use with Bullseye Glass of average viscosity with an even thickness of 4 - 6 mm. The chart shown below is also based on the assumption that you are using a top fired kiln, e.g. Paragon GL22, GL24, BVD Flat bed kilns etc. If you are using a side firing kiln you must allow more time in the first ramp.
7648 1.330000